MSEd: Education Technology Specialist
Recent studies by the International Society for Technology in Education (ISTE) highlight the disparity between educational technology advances and the skills of teachers to use those advances in the classroom. To address that disparity, Pace’s School of Education has voluntarily adopted the ISTE National Educational Technology Standards (NETS) not only for our programs in Educational Technology, but for all teacher preparation programs.
- Bachelor’s degree or higher from an accredited institution.
- Minimum GPA of 3.0. (Upon the recommendation of the dean, graduate faculty admissions committee, or the director of Student Support Services or program coordinators, candidates whose GPA is greater than 2.8 and less than 3.0 may be admitted on a conditional/provisional basis, provided that it is determined that the candidate has the necessary knowledge and skills to complete the program successfully).
- A transcript review of liberal arts and sciences course requirements required for program completion. If unmet requirements exist, they must be met during the course of the program; however, the credit hours earned completing them may not be counted towards the graduate degree.
- A transcript review will also be performed with the applicant’s undergraduate or previous graduate coursework to determine needed content and pedagogical composition of the individualized Educational Technology Specialist Program.
Completion of the application process including an essay, two letters of recommendation, and in some cases admission interview.
The Educational Technology Specialist program requires a minimum of 36 graduate credits for the master’s degree and 24 graduate credits for the Advanced Certificate, each to be completed within five years. Candidates’ backgrounds in education and in technology will be evaluated on a case-by-case basis, using transcript review and challenge examinations. Each candidate will meet with the faculty (either face-to-face or virtually) to design his/her own professional development plan. Each plan must be designed to meet the competencies stipulated by the State of New York and the International Society of Technology Education.
While exceptions may be made, there is a 18-credit hour Educational Technology Specialist core that most students will take. It consists of the following:
Core Requirements (18 credits)
ED 615 Assistive Technology for Educating Students with Low-Incidence Disabilities (3)
ED 616 Curriculum Development and Instructional Planning with Technology (3)
TS 642 Introduction to Computer Software, Hardware and Networking Technologies (3)
TS 654 Designing Standards-Based, Technology-Enhanced Curriculum (3)
ED 672 Differentiating Curriculum and Instruction (3) or ED 672A Differentiating Curriculum and Instruction in Inclusive and Secondary Settings (3)
Pedagogy Concentration (15 credits)
ED 630 Human Development in the School Context (3)
ED 631 Educational Psychology (3)
ED 640 Secondary Methods: Learning to Teach (3)
ED 692T Student Teaching (6)
Technology Courses (15 credits)
TS 653 Multimedia Tools and Design (3)
TS 643 Networking Technologies (3)
TS 671 Internship in Educational Technology (3)
Additional Requirements (3 credits)
- If candidate is NYS certified teacher, candidate will take 3 credits of elective as approved by advisor.
- If candidate is not NYS certified, candidate will take 3 credits in Literacy.